FixVault
Home › Chevrolet › 2006 › HHR LS, Automatic › Repair and Diagnosis › External Pages › Different car › Section 47 (Sunroof System) › Repair Instructions › Sunroof Module Assembly Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sunroof Module Assembly
    GM1547329Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, position the new sunroof module assembly to the studs located on the roof ring.
  2. Install the center 2 sunroof module to roof nuts and tighten by hand.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the remaining sunroof module to roof nuts (2).

    Tighten:  Tighten all of the nuts to 10 N.m (89 lb in).

  4. Connect the front and rear drain hoses (1) to the drain spouts on the sunroof module.
  5. Install the sunroof window to the new sunroof module. Refer to Sunroof Window Replacement .
  6. Install the sunshade panel to the new sunroof module. Refer to Sunroof Sunshade Panel Replacement .
    7. Fig 2: View Of Sunroof Motor/Actuator Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  7. Connect the electrical connector to the sunroof motor/actuator.
  8. Secure the harness to the sunroof module.
  9. Verify the proper operation of the sunroof before securing the headliner.
  10. Install the headliner. Refer to Headliner Replacement in Interior Trim.
About FixVault