FixVault
Home › Chevrolet › 2006 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 100 (Battery, Charging System And Starting System) › Repair Instructions › Battery Current Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Current Sensor
    GM1631638Courtesy of GENERAL MOTORS CORP.
  1. Install the battery current sensor by passing the ground end of the negative battery cable through the sensor.
    2. Fig 2: Negative Battery Cable
    GM1631636Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the battery current sensor is installed in the correct direction and location on the negative battery cable.
  2. Wrap electrical tape around the battery current sensor in order to secure the battery current sensor to the negative battery cable.
  3. Install the negative battery cable. Refer to Battery Negative Cable Replacement .
About FixVault