FixVault
Home › Chevrolet › 2006 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 15 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Steering Wheel Module Coil Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper washer switch from the SIR coil module assembly. Refer to Wipers/Washer Switch Replacement in Wiper/Washer Systems.
  2. Install the headlamp/turn signal switch to the SIR coil module assembly. Refer to Multifunction, Turn Signal Switch Replacement .
  3. Install the headlamp/turn signal switch screws.
  4. Verify the SIR coil is in the center position. Refer to Inflatable Restraint Steering Wheel Module Coil Centering in Steering Wheel and Column.
  5. Slide the SIR coil assembly on the steering column and snap into place.
    6. Fig 1: View Of SIR Coil Module Assembly Harness Connectors
    GM854953Courtesy of GENERAL MOTORS CORP.
  6. Connect the wiper/washer harness connector to the SIR coil module assembly.
  7. Connect the headlamp/turn signal harness connector to the SIR coil module assembly.
  8. Connect the SIR coil harness connector to the SIR coil module assembly.
  9. Install the steering column covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel in Column.
  10. Install the steering wheel. Refer to Steering Wheel Replacement in Steering Wheel and Column.
  11. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  12. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
About FixVault