FixVault
Home › Chevrolet › 2006 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 18 (Engine Controls - 2.2L - (Introduction)) › Repair Instructions › Ignition Control Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition.
  2. Remove the accelerator cable from the bracket.
  3. Remove the accelerator cable bracket bolt.
  4. Remove the accelerator cable bracket.
    5. Fig 1: View Of ICM
    GM783965Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the ignition control module (ICM) harness connector.
  6. Remove the ICM retaining screws.
  7. Remove the ICM from the ignition coil housing.
About FixVault