FixVault
Home › Chevrolet › 2006 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 19 (Battery, Charging System And Starting System) › Repair Instructions › Battery Negative Cable Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Current Sensor
    GM1548362Courtesy of GENERAL MOTORS CORP.
  1. Connect the sensor (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the negative battery cable bolt (2).

    Tighten:  Tighten the bolt to 20 N.m (15 lb ft).

  3. Connect the negative battery cable (1). Refer to Battery Negative Cable Disconnect/Connect Procedure .
About FixVault