Installation Procedure

Fig 1: Installing The Air Inlet Duct From The MAF/IAT Sensor

Courtesy of GENERAL MOTORS CORP.

Install the air inlet duct from the MAF/IAT sensor.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Tighten the air inlet duct clamp at the MAF/IAT sensor.
Tighten: Tighten the clamp to 3 N.m (27 lb in).
Install the air inlet duct to the throttle body.
Tighten the air inlet duct clamp at the throttle body.
Tighten: Tighten the clamp to 3 N.m (27 lb in).
Connect the PCV tube to the air inlet duct. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .