FixVault
Home › Chevrolet › 2006 › Impala SS › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Computer/Integrating Systems › Diagnostic Information and Procedures › DTC B1440 › Circuit/System Testing

Circuit/System Testing

  1. With the ignition OFF, disconnect the BCM connector.
  2. With the ignition OFF w/key out and in the ACC positions, measure for 0 volts between the off/run/crank voltage circuit at the BCM connector and ground.
    • If over 0 volts, disconnect the ignition switch and check the off/run/crank voltage circuit for short to voltage or short to other ignition switch signal circuit.
  3. With the ignition OFF w/key in, measure for battery voltage between the off/run/crank voltage circuit at the BCM connector and ground.
    • If less than battery voltage, disconnect the ignition switch and check the off/run/crank voltage circuit for an open or short to ground.
  4. With the ignition in the RUN and START positions, measure for battery voltage between the ignition 1 voltage circuit at the BCM connector and ground.
    • If less than battery voltage, disconnect the ignition switch and check the ignition 1 voltage and battery positive voltage circuits for an open or short to ground.
  5. With the ignition in the ACC and RUN positions, measure for battery voltage between the accessory voltage circuit at the BCM connector and ground.
    • If less than battery voltage, disconnect the ignition switch and check the ignition voltage and battery positive voltage circuits for an open or short to ground.
About FixVault