Rear Door Window Regulator Replacement

Fig 1: Replacing Rear Door Window Regulator

Courtesy of GENERAL MOTORS CORP.

Window Regulator Replacement - Rear Door

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Position window approximately half way down in the door. Remove the interior trim panel. Refer to Trim Panel Replacement - Side Rear Door (Impala) . Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Impala) . Tape the window to door frame to prevent it from moving.
1	Rear Side Door Window Regulator Bolts (Qty: 6) Tighten: 10 N.m (89 lb in)
2	Rear Side Door Window Regulator Tip: Disconnect the electrical connector from the window regulator motor. Transfer parts as necessary.

Callout

Component Name

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Position window approximately half way down in the door.
Remove the interior trim panel. Refer to Trim Panel Replacement - Side Rear Door (Impala) .
Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Impala) .
Tape the window to door frame to prevent it from moving.

Rear Side Door Window Regulator Bolts (Qty: 6)

Tighten: 10 N.m (89 lb in)

Rear Side Door Window Regulator
Tip: