FixVault
Home › Chevrolet › 2006 › Impala SS › Repair and Diagnosis › External Pages › Different car › Section 260 (Battery, Charging System And Starting System) › Repair Instructions › Battery Negative Cable Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When installing the negative battery cable, ensure that the cable eyelet is installed with the flat side down. Keep the crimped side facing upward.
    Fig 1: Removing/Installing Negative Battery Cable
    GM1669905Courtesy of GENERAL MOTORS CORP.
  1. Place the negative battery cable eyelet over the hole in the floor pan.
    2. NOTE: Refer to Fastener Notice .
  2. Install the negative battery cable ground bolt.

    Tighten:  Tighten the bolt to 36 N.m (27 lb ft).

  3. Connect the body harness electrical connector to the battery current sensor.
  4. Connect the body harness electrical connector to the negative battery cable electrical connector.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
About FixVault