FixVault
Home › Chevrolet › 2006 › Malibu Maxx LS › Repair and Diagnosis › Engine Performance › System › Engine Control System - 3.5L - Introduction (2 Of 2) › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Installation Procedure

Installation Procedure

  1. Lubricate the O-ring with clean engine oil and replace the O-ring if damaged.
    Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP sensor.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Connect the CMP sensor electrical connector.
About FixVault