FixVault
Home › Chevrolet › 2006 › Malibu Maxx LS › Repair and Diagnosis › Engine Performance › System › Engine Control System - 3.5L - Introduction (2 Of 2) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Installing MAP Sensor And MAP Sensor Seal From Upper Intake Manifold
    GM1239001Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor and MAP sensor seal into the upper intake manifold.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the MAP sensor attaching screw.

    Tighten:  Tighten the attaching screw to 6.5 N.m (5.7 lb in).

  3. Connect the MAP sensor electrical connector.
About FixVault