FixVault
Home › Chevrolet › 2006 › Optra5 LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 21 (Wipers/Washer Systems) › Repair Instructions › Wiper Motor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Optra5 and 2005 Chevrolet Optra. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Motor Bolts
    GM1308529Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the wiper motor with the bolts.

    Tighten:  Tighten the wiper motor bolts to 8 N.m (71 lb in)  .

  2. Connect the electrical connector.
    3. Fig 2: Identifying Wiper Arm Linkage Bolts
    GM1308528Courtesy of GENERAL MOTORS CORP.
  3. Press the wiper arm linkage onto the motor driveshaft.
  4. Install the wiper arm linkage to the motor driveshaft with the washer and the nut.

    Tighten:  Tighten the wiper arm linkage nut to 5 N.m (44 lb in)  .

  5. Install the left side portion of the cowl vent grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  6. Connect the negative battery cable.
About FixVault