Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Connector To Wiring Harness

Courtesy of GENERAL MOTORS CORP.

Slide the wiper/washer switch into the steering column lock module until the upper and lower retaining clips snap into place.
Connect the electrical connector into the wiring harness.

Fig 2: Driver Knee Bolster Trim Panel At Steering Column Covers

Courtesy of GENERAL MOTORS CORP.

Install the upper (1) and the lower (3) steering column covers.
Install the tilt wheel lever (4). Refer to Tilt Lever Replacement .
Install the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .