Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Sunshade & Screws

Courtesy of GENERAL MOTORS CORP.

Install the sunshade to the windshield header
Connect the harness to the sunshade electrical connector.
Push the connector through the hole into the windshield header.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the sunshade retaining screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Rotate the sunshade toward the centerline of the vehicle until the sunshade locks in place.