Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Leaf Spring Fixture (J 33432-A)

Courtesy of GENERAL MOTORS CORP.

If installing a new transverse spring, install the J 33432-A and compress the spring.
Install the transverse spring to the crossmember.

Fig 2: Transverse Spring Bolts, Retainers & Crossmember

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

NOTE: Do not remove the transverse leaf spring compressor tool until after the shock absorber has been installed. The pad on the transverse leaf spring bolt could move out of position resulting in damage to the pad or a rattle in the suspension.

IMPORTANT: Use NEW transverse spring retainer-to-crossmember bolts.

Install the transverse spring retainers and NEW mounting bolts to the crossmember.
Tighten: Tighten the bolts to 62 N.m (46 lb ft).

Fig 3: Lower Control Arm, Crossmember & Components

Courtesy of GENERAL MOTORS CORP.

Install the lower control arm to the rear crossmember. Refer to Rear Axle Lower Control Arm Replacement .

Fig 4: Leaf Spring Fixture (J 33432-A)

Courtesy of GENERAL MOTORS CORP.

Remove the J 33432-A .
Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
If a NEW transverse spring was installed, adjust the rear trim height. Refer to Trim Height Inspection .
Perform a rear wheel alignment. Refer to Measuring Wheel Alignment .