FixVault
Home › Chevrolet › 2006 › SSR Standard › Repair and Diagnosis › External Pages › Different car › Section 19 (Automatic Air Conditioning Heater System) › Repair Instructions › HVAC Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Connecting The HVAC Control Module Electrical Connections
    GM1488655Courtesy of GENERAL MOTORS CORP.
  1. Connect the HVAC control module electrical connections.
    2. Fig 2: Installing The HVAC Control Module Retaining Screws
    GM1488652Courtesy of GENERAL MOTORS CORP.
  2. Install the HVAC control module to the I/P trim plate.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the HVAC control module retaining screws.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  4. Connect the electrical connectors to the HVAC control module.
  5. Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.
    IMPORTANT: Do not adjust any controls on the HVAC control module while the HVAC control module is self-calibrating. If interrupted, improper HVAC performance will result.
    The engine must be running for proper calibration to occur.
  6. Start and allow the engine to run for at least one minute.
About FixVault