Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Front End Sensor & Retaining Bolts

GM1226200

Courtesy of GENERAL MOTORS CORP.

Install the sensor from the vehicle.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the retaining bolts to the inflatable restraint front end sensor.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .