Fog Lamp Replacement - Front

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Front Fog Lamp

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Remove the front bumper fascia. Refer to Fascia, Valence, Fascia Close Out Panel Replacement - Front Bumper . Disconnect the front fog lamp bulb socket electrical connectors.
1	Front Fog Lamp Mounting Screws (Qty: 3) Tighten: 4 N.m (35 lb in)
2	Front Fog Lamp Tip: Lower the fog lamp in order to release the upper alignment pins from the tabs on the front fascia.

Callout

Component Name

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
Remove the front bumper fascia. Refer to Fascia, Valence, Fascia Close Out Panel Replacement - Front Bumper .
Disconnect the front fog lamp bulb socket electrical connectors.

Front Fog Lamp Mounting Screws (Qty: 3)

Tighten: 4 N.m (35 lb in)

Front Fog Lamp
Tip: Lower the fog lamp in order to release the upper alignment pins from the tabs on the front fascia.