FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › Brakes › Antilock Brake System With Traction Control System & Stability Control System › Repair Instructions › Yaw Rate Sensor/Lateral Accelerometer Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Electronic Brake Control Module
    GM1538732Courtesy of GENERAL MOTORS CORP.
  1. Install the yaw rate sensor (1) to the console bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts (2) retaining the yaw rate sensor.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  3. Connect the electrical connector (3) to the yaw rate sensor.
  4. Install the front floor console reinforcement. Refer to Bracket, Reinforcement, Side Trim Panel Replacement - Front Floor Console in Instrument Panel, Gages and Console.
About FixVault