FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › External Pages › Different car › Section 110 (Theft Deterrent System) › Repair Instructions › Theft Deterrent Exciter Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Theft Deterrent Control Module
    GM884916Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement (Manual Tilt) in Steering Wheel and Column.
  3. Remove the lock cylinder. Refer to Ignition Lock Cylinder Replacement in Steering Wheel and Column.
  4. Disconnect the connector from the theft deterrent exciter module.
  5. If necessary, disconnect the connector from the ignition lock cylinder case.
  6. Remove the theft deterrent exciter module from ignition lock cylinder case assembly.
About FixVault