FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › External Pages › Different car › Section 13 (Seat System) › Repair Instructions › Drive Cable Replacement - Horizontal › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Seat Components
    GM817977Courtesy of GENERAL MOTORS CORP.
  1. If one side of the seat adjuster is not working, perform the following procedure:
    1. The horizontal drive motor (1) and the drive cables (4) are located at the front of the seat. Verify that both cables are straight. If a cable is bent, an end will be pulled out of the drive motor or the drive screw. Straighten the cable. The seat switch may have to be toggled back and forth to get the cable ends to seat properly.
    2. Run the seat forward until the seat removal bolts are accessible.
  2. Remove the front seat. Refer to Seat Replacement - Front Bucket .
  3. Tip the seat forward and disconnect the electrical connector from the seat electrical harness.
  4. Disengage the seat hook attachments from the floor pan.
  5. Tip the seat rearward to expose the horizontal drive cables (4).
    6. IMPORTANT: The short cable is not replaceable.
  6. Bend the long flexible cable at the center and pull the cable out of the motor (1) and the drive screw (3).
  7. Remove the cable from the vehicle.
About FixVault