FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › External Pages › Different car › Section 198 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Module Wiring Harness Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to SIR Inflator Module Handling and Storage Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7  or SIR Disabling and Enabling Zone 9 (Monte Carlo)  or SIR Disabling and Enabling Zone 9 (Impala) .
  2. Remove the side impact inflator module from the seat. Refer to Inflatable Restraint Side Impact Module Replacement - Front (Monte Carlo) .
    3. Fig 1: Inflatable Restraint Side Impact Module Wiring Harness At Seat Frame With Retaining Clips
    GM1276234Courtesy of GENERAL MOTORS CORP.
  3. With the seat back cover in the open position the wiring harness on the side impact inflator module will be exposed.

    Remove the retaining clips that secure the inflator module wiring harness to the seat.

  4. Remove the wiring harness.
About FixVault