Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the knuckle to the vehicle.
NOTE: Refer to Fastener Notice .

Fig 1: View Of Steering Knuckle To Strut Bolts

Courtesy of GENERAL MOTORS CORP.

Install the bolts and nuts attaching the strut to the knuckle.
Tighten: Tighten the strut to knuckle bolts to 130 N.m (96 lb ft).
Install the outer tie rod to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
Connect the front lower control arm ball stud to the knuckle. Refer to Lower Control Arm Replacement .
Install the front wheel drive shaft bearing. Refer to Wheel Bearing/Hub Replacement - Front .
Lower the vehicle.
Inspect the front wheel alignment and adjust, if necessary. Refer to Measuring Wheel Alignment .