Installation Procedure
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Position the rear suspension support in place.NOTE: Refer to Fastener Notice .
- Install the rear wheel spindle rod-to-rear suspension support bolts and nuts.
Tighten: Tighten the nuts to 135 N.m (100 lb ft).
- Install the rear suspension support mounting bolts.
Tighten: Tighten the bolts to 110 N.m (81 lb ft).
- Position the rear wheel spindle rod to the knuckle.
- Install the retaining bolts and nuts to the knuckle.
Tighten: Tighten the nut to 150 N.m (111 lb ft).
- Install the stabilizer shaft to the rear suspension support. Refer to Stabilizer Shaft Replacement .
- Connect the brake lines to the rear suspension support. Refer to Brake Hose Replacement - Rear .
- Install the parking brake cables and the tensioner. Refer to Park Brake Cable Replacement - Rear (Z7U) .
- Install the exhaust pipe. Refer to Muffler Replacement (Single Outlet) or Muffler Replacement (Dual Outlet) .
- Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Adjust the rear wheel alignment. Refer to Measuring Wheel Alignment .