FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › External Pages › Different car › Section 281 (Rear Suspension System) › Repair Instructions › Spindle Rod Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the spindle rod (5) to the vehicle.
    Fig 1: View Of Spindle Rod, Knuckle, And Bolt
    GM803927Courtesy of GENERAL MOTORS CORP.
  2. Install the spindle rod (5) to the knuckle (8).
  3. Install the spindle rod to knuckle bolt (4) and nut.

    Tighten:  Tighten the nut to 150 N.m (110 lb ft).

    NOTE: Refer to Fastener Notice .
  4. Install the spindle rod to the rear suspension support.
    Fig 2: View Of Spindle Rod & Rear Suspension Support Bolt
    GM614974Courtesy of GENERAL MOTORS CORP.
  5. Install the bolt (1) and nut to the rear suspension support.

    Tighten:  Tighten the bolt to 135 N.m (100 lb ft).

  6. Install the rear suspension support. Refer to Support Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
  9. Adjust the wheel toe angle. Refer to Wheel Alignment Specifications in Wheel Alignment.
About FixVault