FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › External Pages › Different car › Section 281 (Rear Suspension System) › Repair Instructions › Support Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear suspension support in place.
    Fig 1: Rear Suspension Components
    GM156917Courtesy of GENERAL MOTORS CORP.
  2. Install the rear wheel spindle rod-to-rear suspension support bolts and nuts.

    Tighten:  Tighten the nuts to 135 N.m (100 lb ft).

    NOTE: Refer to Fastener Notice .
  3. Install the rear suspension support mounting bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

  4. Position the rear wheel spindle rod to the knuckle.
  5. Install the retaining bolts and nuts to the knuckle.

    Tighten:  Tighten the nut to 150 N.m (111 lb ft).

  6. Install the stabilizer shaft to the rear suspension support. Refer to Stabilizer Shaft Replacement .
  7. Connect the brake lines to the rear suspension support. Refer to Rear Brake Hose Replacement .
  8. Install the parking brake cables and the tensioner. Refer to Park Brake Cable Replacement - Rear (Z7U) .
  9. Install the exhaust pipe. Refer to Muffler Replacement (Dual Outlet) or Muffler Replacement (Single Outlet) .
  10. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
  12. Adjust the rear wheel alignment. Refer to Measuring Wheel Alignment .
About FixVault