FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › External Pages › Different car › Section 285 (Disc Brake System) › Repair Instructions › Disc Brake Hardware Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the bores (3), the inside part of the bolt boot (2) and the caliper pin bolts (4) with GM P/N 18047666, or equivalent.
    Fig 1: Identifying Caliper Guide Pin & Caliper Pin Bolts
    GM793825Courtesy of GENERAL MOTORS CORP.
  2. Press the new caliper pin bolt boots into the caliper pin bores.
  3. Install the brake caliper bracket. Refer to Brake Caliper Bracket Replacement - Front .
  4. Install the brake pad retainers (1) to the caliper bracket.
    Fig 2: View Of Brake Pads, Brake Pad Retainers, & Caliper Bracket
    GM727742Courtesy of GENERAL MOTORS CORP.
  5. Install the brake pads (2) to the caliper bracket.
  6. Remove the heavy mechanics wire (1) and install the brake caliper. Refer to Front Brake Caliper Replacement .
    Fig 3: View Of Brake Caliper & Caliper Bracket
    GM178630Courtesy of GENERAL MOTORS CORP.
About FixVault