FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › External Pages › Different car › Section 35 (Wiper System & Washer System) › Repair Instructions › Wiper Drive System Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiper Drive System Module & Screws
    GM815220Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper drive system module to the vehicle.
  2. Connect the wiper motor electrical connector.
  3. Rotate the wiper drive system module to the mounting position.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the wiper drive system module screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  5. Install the wiper transmission link to the wiper motor crank arm using the J 39529  .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  7. Inspect the wipers for proper operation.
About FixVault