FixVault
Home › Chevrolet › 2006 › Uplander Base › Repair and Diagnosis › Suspension › Electronic Suspension › Suspension Control System - Suspension Leveling › Repair Instructions › Automatic Level Control Sensor Link Ball Stud Replacement › Removal Procedure

Removal Procedure

  1. Remove the ELC/TRAILER fuse.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Locating Automatic Level Control Sensor Link Ball Stud
    GM380438Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When removing the link, do NOT bend or break the sensor arm.
  3. Remove the automatic level control sensor link from the rear suspension ball stud.
  4. Remove the ball stud from the rear suspension.
About FixVault