FixVault
Home › Chevrolet › 2007 › Aveo Base › Repair and Diagnosis (Single Page) › Engine Performance › System › Engine Controls & Fuel - 1.6L - Introduction (2 Of 2) › Repair InstructionsEngine Control Module Replacement › Knock Sensor ReplacementRemoval Procedure › Removal ProcedureInstallation Procedure

Removal ProcedureInstallation Procedure

    Fig 1: Removing And Installing Knock Sensor
    GM1241935Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Remove the intake manifold. Refer to Intake Manifold Replacement .
  3. Disconnect the knock sensor (KS) electrical connector.
  4. Remove the KS.
About FixVault