Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 GMC Savana Special, 2006 GMC Savana Camper Special, 2006 GMC Savana, 2006 Chevrolet RV Cutaway, and 2006 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Nuts That Retain Cruise Control Module To Cruise Control Bracket

Courtesy of GENERAL MOTORS CORP.

Install the cruise control module (3) to the vehicle.
Install the cruise control module (3) to the cruise control bracket (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts (2) that retain the cruise control module (3) to the cruise control bracket (1).
Tighten: Tighten the nuts to 5 N.m (44 lb in).
Connect the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement .
Connect the electrical connector to the cruise control module.
Install the air cleaner assembly to the vehicle.
- For the 4.3L engine, refer to Air Cleaner Assembly Replacement in Engine Controls - 4.3L.
- For the 4.8L, 5.3L, or 6.0L engine, refer to Air Cleaner Assembly Replacement in Engine Controls - 4.8L, 5.3L, and 6.0L.
Close the hood.