FixVault
Home › Chevrolet › 2007 › Chevy Express G3500, Van Passenger Extended › Repair and Diagnosis › External Pages › Different car › Section 819 (Antilock Brake System With Traction Control System & Stability Control System) › Repair Instructions › Electronic Brake Control Module Replacement (w/JL4) › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 GMC Savana Special, 2006 GMC Savana Camper Special, 2006 GMC Savana, 2006 Chevrolet RV Cutaway, and 2006 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Pressure Modulator Valve & Electronic Brake Control Module
    GM1381552Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install the EBCM (2) on to the BPMV (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the EBCM (2).

    Tighten:  Tighten the screws to 5 N.m (44 lb in) in an X-pattern.

    3. Fig 2: Identifying Chassis Electrical Connectors To EBCM
    GM924296Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors to the EBCM.
    4. Fig 3: Splash Shield (Cutaway Vehicles)
    GM1209085Courtesy of GENERAL MOTORS CORP.
  4. For cutaway vehicles, install the splash shield.

    Tighten:  Tighten the splash shield bolts to 25 N.m (18 lb ft).

  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  7. Revise the tire calibration using the Tire Size Calibration function.
  8. Verify correct system operation. Refer to Diagnostic Starting Point - Anti-Lock Brake System .
About FixVault