Installation Procedure

Fig 1: Warning Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Align the park brake warning lamp switch locating tab to the locating hole on the park brake lever assembly.
Install the switch to the park brake lever.

NOTE: Refer to Fastener Notice .

Install the park brake warning lamp switch mounting screw (2).
Tighten: Tighten the screw to 3 N.m (27 lb in).
Connect the park brake warning lamp switch electrical connector (1).
Install the console rear trim plate. Refer to Console Rear Trim Plate Replacement .
Verify correct park brake warning lamp operation.