FixVault
Home › Chevrolet › 2007 › Impala LTZ › Repair and Diagnosis › Transmission › Automatic Trans › Shift Interlock System › Repair Instructions › Automatic Transmission Shift Lock Actuator Replacement › Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) or Battery Negative Cable Disconnection and Connection (RPOs LZE/LZ4/LZ9) .
    Fig 1: Automatic Transaxle Shift Lock Actuator Electrical Connector
    GM1218843Courtesy of GENERAL MOTORS CORP.
  2. Remove the center console. Refer to Front Floor Console Replacement (Impala) or Front Floor Console Replacement (Monte Carlo) .
    NOTE: To prevent component damage, DO NOT use metal tools to remove the trim.
    IMPORTANT: Use only a plastic trim tool to lift the shift lever bezel or trim plate. Do not use any tool between the shift lever bezel or trim plate and the shifter.
  3. Disconnect the automatic transaxle shift lock actuator electrical connector (1).
  4. Remove both ends of the automatic transaxle shift lock actuator from the pivot points.
About FixVault