Inflatable Restraint Side Impact Module Replacement - Rear

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Inflatable Restraint Rear Side Impact Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: The seat cushion frame The seat recliner, if equipped The seat adjuster The seat back frame Failure to do so may cause future personal injury. NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Disable the SIR, if equipped. Refer to SIR Disabling and Enabling Zone 10 and SIR Disabling and Enabling Zone 12 . Remove the rear seat from the vehicle. Refer to Seat Replacement - Rear .
1	Armrest Assembly Refer to Armrest Replacement - Front Seat .
2	Head Restraint Assembly Refer to Head Restraint Replacement - Front Seat .
3	Cover, Seat Back Cushion Tip: Slide the seat back cushion up far enough to gain access to the side impact inflatable restraint nuts.
4	Nut, Side Impact Inflatable Restraint (Qty: 2) Tighten: 5 N.m (44 lb in)
5	Cover, Side Impact Air Bag Escutcheon
6	Module Assembly, Inflatable Restraint Tip: Disconnect the electrical connector. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .