Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to Fastener Notice
.
- Install the ball stud to the rear suspension.
Tighten: Tighten the height sensor ball stud to 4 N.m (35 lb in).
- Install the automatic level control sensor link to the rear suspension ball stud.
- Lower the vehicle.
- Install the ELC/TRAILER fuse.