FixVault
Home › Chevrolet › 2007 › Impala SS › Repair and Diagnosis › External Pages › Different car › Section 211 (Suspension Control System - Suspension Leveling) › Repair Instructions › Automatic Level Control Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ELC/TRAILER fuse.
    2. IMPORTANT: When replacing the height sensor a diagnostic system check must be performed.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 1: View Of Automatic Level Control Sensor Electrical Connector
    GM881329Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the automatic level control sensor electrical connector (1).
  4. Remove the automatic level control sensor link from the sensor arm ball stud.
    5. Fig 2: Identifying Automatic Level Control Height Sensor Bracket Bolts
    GM881333Courtesy of GENERAL MOTORS CORP.
  5. Remove the automatic level control sensor bracket bolts (1).
  6. Remove the automatic level control sensor from the vehicle.
About FixVault