Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the wheel. Refer to Tire and Wheel Removal and Installation .
If equipped with a LX9 engine, perform one of the following steps:
- If removing the left lower control arm, remove the side transmission mount. Refer to Transmission Mount Replacement - Left Side (W/L61) or Transmission Mount Replacement - Left Side (W/ LZ4) .
- If removing the right lower control arm, remove the engine mount. Refer to Engine Mount Replacement .

Fig 1: Identifying Lower Control Arm Rear Bushing To Frame Bolts And Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the front lower control arm bushing to frame bolt and nut.
Remove the rear lower control arm bushing to frame bolts and nuts.

Fig 2: Identifying Steering Knuckle Pinch Bolt

Courtesy of GENERAL MOTORS CORP.

Prior to removal, note the orientation of the lower control arm ball stud to steering knuckle pinch bolt and remove the pinch bolt and discard.
Separate the ball stud from the steering knuckle.

Fig 3: View Of Lower Control Arm (W/L61)

Courtesy of GENERAL MOTORS CORP.

Remove the control arm from the vehicle.
Remove the rear lower control arm bushing. Refer to Front Lower Control Arm Bushing Replacement .