Headlamp Replacement

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Headlamp

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front bumper fascia upper bracket. Refer to Front Bumper Fascia Bracket Replacement (Lower) or Front Bumper Fascia Bracket Replacement (Upper) .
1	Headlamp Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tip: Secure the headlamp fasteners in sequence, as indicated. Tighten: 3 N.m (27 lb in)
2	Headlamp Assembly Procedure Pull forward on the outside edge of the headlamp in order to release the up and down locator tabs on the backside of the headlamp. Pull forward on the top inside edge of the headlamp to release the inboard up/down locator. Pull the headlamp assembly down. Pull the headlamp assembly forward far enough to access the electrical connection. Disconnect the headlamp electrical connector from the forward lamp harness connector. Remove the headlamp assembly. Aim the headlamps after installation. Refer to Headlamp Aiming .

Callout

Component Name

Preliminary Procedure:
Remove the front bumper fascia upper bracket. Refer to Front Bumper Fascia Bracket Replacement (Lower) or Front Bumper Fascia Bracket Replacement (Upper) .

Headlamp Screw (Qty: 2)

NOTE: Refer to Fastener Notice .

Tip: Secure the headlamp fasteners in sequence, as indicated.

Tighten: 3 N.m (27 lb in)

Headlamp Assembly

Procedure

Pull forward on the outside edge of the headlamp in order to release the up and down locator tabs on the backside of the headlamp.
Pull forward on the top inside edge of the headlamp to release the inboard up/down locator.
Pull the headlamp assembly down.
Pull the headlamp assembly forward far enough to access the electrical connection.
Disconnect the headlamp electrical connector from the forward lamp harness connector.
Remove the headlamp assembly.
Aim the headlamps after installation. Refer to Headlamp Aiming .