Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

If needed, replace the upper (2) or the lower (3) spring insulator.

Fig 1: Installing Lower Control Arm With The Coil Spring Attached

Courtesy of GENERAL MOTORS CORP.

NOTE: When installing the rear spring, ensure that the spring is positioned so that bolt for the rear stabilizer shaft can be serviced and that the rear spring is properly seated in the upper and lower insulators.

Position the rear spring (1) on the lower control arm.
Using an adjustable jack stand, raise the lower control arm.
Install the lower control arm to knuckle bolt and nut. Refer to Rear Axle Lower Control Arm Replacement .
Remove the jack stands from the knuckle vehicle and the lower control arm.
Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Check the rear wheel alignment. Refer to Wheel Alignment Measurement .