FixVault
Home › Chevrolet › 2007 › Optra LS, Standard › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - ZF 4HP 16 - Specifications, Component Locations And Repairs › Repair Instructions › Park/Neutral Position Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of DT 46473
    GM1255927Courtesy of GENERAL MOTORS CORP.
  1. Place the shift lever in Neutral.
    2. NOTE: Refer to Fastener Notice .
  2. Install the park/neutral start switch.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in)  .

  3. Use DT 46473  (1) to adjust the start switch. See Special Tools .
    4. Fig 2: Identifying Shift Lever And Nut
    GM1255928Courtesy of GENERAL MOTORS CORP.
  4. Install the shift lever and the shift lever nut.

    Tighten:  Tighten the nut to 10 N.m (89 lb in)  .

    5. Fig 3: Identifying Shift Control Cable And Retaining Clip
    GM1290880Courtesy of GENERAL MOTORS CORP.
  5. Connect the shift control cable and the retaining clip.
  6. Connect the electrical connector to the park/neutral position switch.
  7. Connect the negative battery cable.
About FixVault