FixVault
Home › Chevrolet › 2008 › Aveo Base › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 1.6L - Introduction (2 Of 2) › Repair Instructions › Throttle Body Assembly Replacement › Removal Procedure

Removal Procedure

    Fig 1: Intake Air Temperature Sensor Connector
    GM1915906Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Disconnect the intake air temperature sensor connector.
  3. Remove the air cleaner inlet duct from the throttle body.
    4. Fig 2: Coolant Hoses At Throttle Body
    GM1917288Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electronic throttle body connector.
  5. Disconnect the coolant hoses from the electronic throttle body.
    6. Fig 3: Throttle Body Retaining Bolts
    GM1917304Courtesy of GENERAL MOTORS CORP.
  6. Remove the throttle body retaining bolts.
  7. Remove the throttle body and discard the gasket.
About FixVault