Circuit/System Testing

Ignition OFF, disconnect the harness connector at the HO2S 2.
Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit terminal and ground.
- HO2S 2 (Euro IV) low reference circuit terminal 3
- HO2S 2 (Non Euro IV) low reference circuit terminal 1
- If greater than the specified range, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
Engine running, verify the scan tool HO2S 2 parameter is between 350-500 mV.
- If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
Verify none of the following conditions exist:
- Rich fuel injectors-Refer to Fuel Injector Balance Test with Special Tool .
- Water intrusion in the HO2S harness connector.
- High fuel system pressure-Refer to Fuel System Diagnosis .
- Fuel that is contaminated-Refer to Alcohol/Contaminants-in-Fuel Diagnosis .
- Fuel saturation of the evaporative emission (EVAP) canister.
- Exhaust leaks near the HO2S.
- Contaminated HO2S-Silicon.
- If you find any of the above conditions, repair as necessary.
If all circuits test normal, test or replace the HO2S.