FixVault
Home › Chevrolet › 2008 › Chevy Express G2500, Van Passenger › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Data Communication System › Repair Instructions › Body Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating BCM & Bracket
    GM923652Courtesy of GENERAL MOTORS CORP.
  1. Install the BCM (1) into the bracket.

    Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

    2. Fig 2: Body Control Module & Electrical Connectors
    GM923655Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connectors (2) to the BCM (1).
    3. Fig 3: Right Side Knee Bolster Trim Panel
    GM853308Courtesy of GENERAL MOTORS CORP.
  3. Install the right side knee bolster trim panel. Refer to Passenger Knee Bolster Replacement .
  4. If you replaced the BCM, program the module. Refer to Body Control Module Programming and Setup .
  5. Refer to Control Module References for programming and setup information.
About FixVault