FixVault
Home › Chevrolet › 2008 › Corvette Base, 2D Convertible, Automatic › Repair and Diagnosis › External Pages › Different car › Section 138 (Suspension Control System - Automatic Level Control) › Repair Instructions › Automatic Level Control Sensor and Bracket Replacement (Front) › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Locating Front Ride Sensor Link
    GM1371682Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the front ride sensor link from the upper control arm ball stud.
  4. Disconnect the front ride sensor harness connector.
    5. Fig 2: View Of Front Ride Sensor
    GM1371680Courtesy of GENERAL MOTORS CORP.
  5. Loosen the front ride sensor retaining nut.
  6. Gently tap the front ride sensor retaining stud in order to loosen the stud to fender connection.
  7. Remove the front ride sender from the vehicle.
About FixVault