FixVault
Home › Chevrolet › 2008 › Corvette Z06 › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Pump Pulley Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Power Steering Pump Pulley Installer
    GM643361Courtesy of GENERAL MOTORS CORP.
  1. Using J 25033-C  , install the power steering pump pulley onto the power steering pump.
    2. Fig 2: Identifying Axial Tolerance Of Power Steering Pulley On Pump
    GM254752Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The pulley must be installed onto pump shaft so that the pulley hub is flush to within 0.25 mm (0.010 in) with the pump shaft.
  2. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  3. Install the BPMV bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
  4. Install the BPMV. Refer to Brake Pressure Modulator Valve Replacement .
About FixVault