Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Sunroof Module

Courtesy of GENERAL MOTORS CORP.

With the aid of an assistant, position the sunroof module assembly to the roof ring.

CAUTION: Refer to Fastener Caution

Install the sunroof module bolts to the roof ring and tighten to 10 N.m (89 lb in).

Fig 2: View Of Bolts Securing Sunroof Module Motor Base To Roof

Courtesy of GENERAL MOTORS CORP.

Using the access hole in the sunroof module cross bar, install the push-pin fastener which secures the rear sunroof water gutter to the roof.
Install the sunroof motor/actuator bolts to the base of the sunroof module and tighten to 2 N.m (18 lb in).

Fig 3: View Of Sunroof Front Drain Hose

Courtesy of GENERAL MOTORS CORP.

Connect the front and rear drain hoses to the drain spigots.
Install the sunshade. Refer to Sunroof Sunshade Replacement (CF5)

Fig 4: Identifying Sunroof Motor/Actuator Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Raise and install the headliner. Perform the headliner replacement install steps 5 thru 24. Refer to Headlining Trim Panel Replacement (without DE1) or Headlining Trim Panel Replacement (with DE1)
Verify that the electrical connector is connected to the sunroof motor/actuator.
Install the sunroof window. Adjust as necessary. Refer to Sunroof Window Replacement
Initialize the sunroof motor. Refer to Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor) or Sunroof Motor/Actuator Initialization/Teach Process (New Motor)
Install the sunroof finishing lace. Refer to Sunroof Opening Trim Finish Lace Replacement
Inspect the sunroof for proper operation.