FixVault
Home › Chevrolet › 2008 › Optra LS, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 1.4L DOHC › Repair Instructions › Camshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Engine Cover Bolts And The Nuts
    GM1289480Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Remove the engine cover bolts and the nuts.
  3. Remove the engine cover.
    4. Fig 2: CMP Sensor Electrical Connector And Bolt
    GM1289481Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the camshaft position (CMP) sensor electrical connector.
  5. Remove the timing belt front cover. Refer to Timing Belt Replacement .
  6. Remove the CMP sensor bolts.
  7. Remove the CMP sensor from the top.
About FixVault