FixVault
Home › Chevrolet › 2008 › Optra LS, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 1.8L (LDA) › Repair Instructions › Manifold Absolute Pressure Sensor Replacement › Installation Procedure

Installation Procedure

  1. Connect the MAP sensor connector to the MAP sensor.
  2. Install the MAP sensor into the intake manifold.
    3. NOTE: Refer to Fastener Notice .
    Fig 1: View Of MAP Sensor And Retaining Bolt
    GM1701074Courtesy of GENERAL MOTORS CORP.
  3. Install the MAP sensor retaining bolt.

    Tighten:  Tighten the MAP sensor retaining bolt to 8 N.m (71 lb in)  .

  4. Connect the fuel rail. Refer to Fuel Injection Fuel Rail Assembly Replacement .
  5. Connect the negative battery cable.
About FixVault