FixVault
Home › Chevrolet › 2008 › Uplander Base, 3.9 W › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Immobilizer System › Repair Instructions › Theft Deterrent Module Replacement › Removal Procedure

Removal Procedure

  1. Disable the SIR. Refer to SIR Disabling and Enabling .
  2. Remove the trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  4. Remove the theft deterrent module (TDM) wiring harness from the steering column harness.
  5. Disconnect the electrical connector.
    6. Fig 1: View Of Theft Deterrent Control Module
    GM860152Courtesy of GENERAL MOTORS CORP.
  6. Pull the TDM (2) away from the lock cylinder housing (1).
About FixVault